MASTOREMATA D.I.Y. SHOP - ONLINE | ARALDITE STANDARD 30ML (ΙΣΧΥΡΗ ΕΠΟΞΕΙΔΙΚΗ 2 ΣΥΣΤΑΤΙΚΩΝ ΑΡΓΗ ΠΗΞΕΩΣ -80 ΛΕΠΤΩΝ)
printerFriendly by cloudcms®
ARALDITE STANDARD 30ML (2 PART EXTRA STRONG EPOXY SLOW CURING ADHESIVE - 80 MIN)
ARALDITE STANDARD is a multi-purpose, heavy duty 2
component epoxy adhesive with long open time, supplied in tubes. It is a
strong, long lasting, solvent free adhesive which is water resistant
and can be painted or sanded. Perfect for complicated jobs which require
adjustment thanks to a long open time. Sets in 8 hours.
ADVANTAGES
- Extra strong bonding
- Long working time
- Easy application
- Bonds a variety of materials
- Temperature resistant (-30oC - +80oC)
- Humidity resistant
- Sandable and paintable
- Fills uneven breaks
- Withstands rough handling
- 100% solid content
- Solvent free
Colour: clear
APPLICATIONS
ARALDITE STANDARD bonds a variety of materials including metal, wood,
ceramics, masonry, glass, dry concrete, chipboard, leather, cardboard,
most hard plastics, fabrics and rubbers (not suitable for polyethylene,
polypropylene, Teflon, expanded polystyrene).
IMPORTANT:
ARALDITE STANDARD is not suitable for bonding rear-view mirrors to car
windscreens. Do not use for items, which may contain food or drink, as
the joint however secure and clean it may appear, may entrap bacteria
from the environment. Not intended for repairs on safety critical items
e.g. rotating parts of hover mowers. Please note that some items are
molded from polymers such as polythene or polypropylene, for example,
and are simply not designed for repair. Repair may not be viable or
would need specialist chemical treatment to achieve a bond.
INSTRUCTIONS FOR USE
- Make sure surfaces are dry, clean and free from dust, dirt and
grease. For even better bonding slightly roughen surfaces with
sandpaper.
- Remove cups from the tubes.
- Dispense equal volumes of resin and hardener onto a clean disposable
surface. Mix well for 30 seconds, by stirring and folding, with the
plastic palette knife provided. It is important to ensure a thorough
mix. Reseal the tubes as soon as possible.
- Apply the mixed adhesive to both surfaces of the joint and assemble
carefully. A layer of adhesive 0.05 to 0.10 mm thick will normally
impart the greatest lap shear strength to the joint.
- Keep the joint supported until set. A rubber band or sticky tape is
ideal. An approximate guide to support and handling times at room
temperature is given below:
Pot life: 90 minutes, approximately at 23oC
Support time: 8 hours at approximately at 23oC
Full strength: 14 hours at 23oC
Setting times may be shorter in hot weather. In cold conditions the
rate of curing of the mixed adhesive may be slowed down significantly
and weak joints may result. For best results, use between 20oC and 25oC - For a perfect finish carefully remove any excess adhesive with a sharp knife before the adhesive has fully hardened.
REMARKS
Thorough mixing is the key to getting a good cured product. Simply
stirring leaves unmixed materials at the margins. Always fold in the
edges then re-stir. Cured adhesive may yellow if exposed to sunlight for
long periods.
Safety Data sheet
Code: SHJ45100002
Price: €7.40
(including 19% VAT)